Last Modified: 11-29-2007 1.6 A
Service Category: Suspension Section: Rear Suspension
Model Year: 2008 Model: Sequoia Doc ID: RM000001JQE002X
Title: REAR SUSPENSION: REAR PNEUMATIC CYLINDER: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY LH

(a) Install the pneumatic cylinder as shown in the illustration.

HINT:

Rotate the pneumatic cylinder to fasten the pneumatic cylinder into the spring seat on the frame.

(b) Connect the height control tube SUSPENSION CONTROL: SUSPENSION CONTROL SYSTEM: PRECAUTION (2008 Sequoia) .

(c) Install a new clip.

(d) Lower the lift that is supporting the frame to allow the tire to touch the floor and check that the piston-side pneumatic cylinder pin is in the center hole of the No. 2 lower arm.

(e) Start the engine to fill the pneumatic cylinder with air.

(f) Install the bolt.

Torque: 17 N·m (173 kgf·cm, 13 ft·lbf)